The Schlage button will illuminate green, followed by one long beep, indicating that the Programming Code has been successfully changed. Re-enter the new Programming Code to complete the operation.Enter a new Programming Code (6 digits), then wait for the Schlage button to light orange three times, followed by three beeps.Press key 3 on the keypad and wait for the Schlage button to light three orange lights, followed by three beeps.Enter the default Programming Code (6 digits) and wait for the Schlage button to light three orange lights, followed by three beeps.If you’re not sure how to change the 6-digit default Programming Code, here is how: The code is usually printed on a yellow/white sticker-located on the user manual and the back of the keypad assembly (requires removing the lock from the door). Perhaps you changed the code previously, but resetting the lock will restore the default Programming Code, so you’ll need to change this code for security reasons. Schlage keypad locks usually come with a 6-digit default Programming Code. Here are some important programming functions to start with: Change the 6 Digits Default Programming Code So you’ll need to start all over again to program the lock. What next after restoring factory default settings on your Schlage Keypad Lock?Īs you probably know, performing a factory reset will delete all your previous programming. More so, see how to reset Schlage Encode and Schlage Sense Deadbolt. If the bolt moves afterward, it means the reset was successful. To confirm if the reset is successful, press the outside Schlage button, then enter one of the preset User Codes (4-digit code).While holding the Schlage button, reconnect the batteries and release the button afterward.Press and hold the outside Schlage button. To reset your Schlage Connect Deadbolt, follow the steps below: Note that this reset method may not work for Schlage Connect, Schlage Encode and Schlage Sense Deadbolt. As you can see, you don’t need to enter any code. That’s all you need to do to reset your Schlage Keypad Lock. To confirm whether the reset is successful, enter one of the default 4-digit codes (User Code) to see if the bolt moves.Ensure you complete this step in 10 seconds. Next, press and hold the Schlage button until the light turns green and the lock beeps. Remove the battery cover (you may need to first remove the screws). Resetting Your Schlage Keypad Lock Without Codeįirst off, you don’t need any code to reset a Schlage Keypad Lock.įollow the steps below to reset your Schlage Keypad Lock (without code):
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |